[TowerTalk] Which crimper die for which connector

[Les Kalmus]

Pete,

Try this page too: 
http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40 
<http://www.tessco.com/products/displayProducts.do?groupId=576&subgroupId=40>
Go about 2/3 down the page.

73, Les W2LK

On 6/7/2011 7:45 AM, Pete Smith wrote:
> I bought a crimping tool at Dayton with two dies, but the openings in
> the dies are identified only by dimensions, not by the connector they
> are to be used on.  I've tried Googling without success, but suspect
> there must be a table somewhere that I can use for reference - any ideas?
>