[TowerTalk] yaesu g800sa

[John Lemay]

Steve

You've had some useful replies, and an explanation of the purpose of
connections to pins 1 to 5.

You say you only have 4 pins connected in your box; there's your problem !

John G4ZTR

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Stevo B
Sent: 02 May 2011 18:59
To: towertalk at contesting.com
Subject: [TowerTalk] yaesu g800sa

Hey Guys,

So, I put the antenna and rotor back up yesterday.  My rotor refuses to
turn.  I am running about 350 feet from the controller to the rotor.

Anyone know of a way to check from the ground if the rotor is good and
possibly just the control box.  I looked inside the control box and only
four wires go to the pin assembly.  Can I just apply power to two of the
correct wires to see if it works?

Appreciate any help you might have.

Steve
N2MAI
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6091 (20110503) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com


 

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 6092 (20110503) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com