[TowerTalk] Rotator Mounting Dimensions

[Bert Almemo]

Hi Larry,

I have the manual for TR-44 but there is no drilling template. I found a
template for the HAM III and I believe it's the same dimensions.  I scanned
the template for you. Good luck!

73 Bert, VE3NR

 

-----Original Message-----
From: towertalk-bounces at contesting.com
[mailto:towertalk-bounces at contesting.com] On Behalf Of Larry Banks
Sent: Wednesday, August 01, 2012 9:30 PM
To: Tower Talk
Subject: [TowerTalk] Rotator Mounting Dimensions

Hi TT'ers

I am designing a base plate for mounting an old TR-44 rotator and cannot
find dimensions anywhere on the Internet.  I measure 3" c-to-c from the
rotator on my workbench.   Is this the correct dimension?  What size hole?
Is this the same for modern Hy Gain rotators too?

(Since I may purchase a new rotator in the future if this one fails, I am
also going to add holes for Yaesu rotators -- at least I know that the
correct dimension there is 84mm for all of them.)

73 -- Larry -- W1DYJ


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk