[TowerTalk] Rohn TB3 Hole Pattern

Mark Robinson markrob at mindspring.com
Thu Dec 20 12:24:42 EST 2012


4 holes of 0.56 inches diameter and the drawing shows the spacing

http://www.3starinc.com/manuals/ROHN_BPL25G.pdf


Mark N1UK


----- Original Message ----- 
From: "Mark Robinson" <markrob at mindspring.com>
To: "Jerry Gardner" <jerryw6uv at gmail.com>; <TowerTalk at contesting.com>
Sent: Thursday, 20 December, 2012 12:20 PM
Subject: Re: [TowerTalk] Rohn TB3 Hole Pattern


> Here is a start...this is the flat plate that the TB3 fits on
>
>
> http://www.3starinc.com/manuals/ROHN_BPL25G.pdf
>
>
> http://www.3starinc.com/rohn_25g_45g_55g_heavy_duty_thrust_bearing_r-tb3.html
>
>
>
> Mark N1UK
>
>
> ----- Original Message ----- 
> From: "Jerry Gardner" <jerryw6uv at gmail.com>
> To: <TowerTalk at contesting.com>
> Sent: Thursday, 20 December, 2012 11:11 AM
> Subject: [TowerTalk] Rohn TB3 Hole Pattern
>
>
>> Anyone have a drawing of the hole pattern needed for the Rohn TB3 thrust
>> bearing they could send me (or point me to)? You'd think this would be on
>> the Rohn web site, but darned if I can find it.
>>
>> 73, Jerry
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> 



More information about the TowerTalk mailing list