[TowerTalk] Lightning Bolt quad antenna information

[Barry N1EU]

FWIW, the aluminum wire used was 1/16in diam which is close to 14AWG

Barry N1EU

On Fri, Mar 2, 2012 at 4:17 PM, Brad Anbro <n9en at charter.net> wrote:
> A long-time ham friend of mine (Gene, W9GD) is a resident in a nursing
> home in Sterling, IL. The management has let him have a short self-
> supporting tower outside of his room and on the tower is a Lightning Bolt
> 2-element quad antenna.
>
> The quad was made with soft aluminum wire and I have had to repair
> the wires two times. Luckily, I was able to reach the damaged portions
> of the wires from the tower.
>
> I was wondering if anyone has had any experience with these antennas,
> in replacing the aluminum wire with copperweld wire. I am guessing that
> the aluminum wire on Gene's quad is around 16 ga. and if I was going
> to replace the wire with Copperweld, I would probably use 18 ga. wire.
>
> Would this reduction in wire size detune the antenna any appreciable
> amount? What would one do to compensate for it? I am hoping to be
> able to convert the aluminum wires to Copperweld this coming spring
> or summer. Thank you very much for any help with this.
>
> 73,
>
> Brad, N9EN
> Roscoe (Rockford), IL
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk