[TowerTalk] connecting more than one stubs

[David Robbins]

yes, you can connect all the stubs for a band to a single T connector.  The diagram shows space between them but that is not necessary.  the only one where spacing is important is the 40m combination of 15'3" and 7'8" MUST be connected to the same T or very close together, the drawing shows a barrel connector, but they can just be connected to a T.


Nov 21, 2012 08:20:38 AM, sv1dpi at otenet.gr wrote:

David tnx for quick reply. Ok with the switch and i can trim the stubs 
for the switch's length but can i connect more than one stub in one 
T-connector? To make that clear i have a switch with 4 positions. Can i 
switch at position 1 for 10m and have there both 23' and 11' stub 
connected? That would be perfect but i am not sure if it is ok...
73 Kostas sv1dpi
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk