[TowerTalk] Rohn 45AG4 guy tabs?

[Jim W7RY]

I agree. Having the guys on the top plate is a real pain. My first Rohn 25 
was like that. It was very frustrating installing a beam with a tram system.

Install a guy ring 4-5 feet down the tower.
73
Jim W7RY


-----Original Message----- 
From: Mark Robinson
Sent: Friday, August 16, 2013 1:59 PM
To: Jay Kesterson
Cc: TowerTalk at contesting.com
Subject: Re: [TowerTalk] Rohn 45AG4 guy tabs?

Yes I believe that they can be used to secure the guys. I chose not to do
this since it is already cluttered up there and having the guys attached to
the top plate makes working on the antennas more difficult.

The angled down guy anchor points on the top plate made a good point to
secure the coax loop though.

I mounted my top guys several feet below the top plate.

73 Mark N1UK



----- Original Message ----- 
From: "Jay Kesterson" <k0gu at verinet.com>
To: "Tower Talk" <TowerTalk at contesting.com>
Sent: Friday, 16 August, 2013 4:42 PM
Subject: [TowerTalk] Rohn 45AG4 guy tabs?


>   I see at least one Rohn 45 seller's web site that calls the tabs on the 
> 45AG4 top plate guy tabs. However I don't see any reference to that in the 
> Rohn documentation. Except for dimensions Rohn doesn't really say a lot 
> about the 45AG4. But Rohn always shows the guys attached a few feet below 
> the tower. So are they guy tabs? I was planning on using them on a tower 
> with a tall mast (the mast is another subject that will get a post here in 
> a bit). Guy the tower at the top plate and then not far under the rotator. 
> Anyone have the scoop on this.
>
> 73,  Jay  K0GU
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk