[TowerTalk] Rohn 45

[Dick Dievendorff]

I have participated in tower building sessions where a 5 foot length of pipe
was inserted into one tower leg and a "modest" (one man) force was applied
at the far end of the pipe to correct alignment.

Dick, K6KR


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
john at kk9a.com
Sent: Wednesday, July 24, 2013 18:52 PM
To: TOWERTALK at contesting.com
Subject: Re: [TowerTalk] Rohn 45

Last week I had the same issue with a piece of new Rohn 55.  I did not
pre-fit them, but did noticed the problem visually and used a floor jack to
straighten it out.  You can easily check all of the leg spacing with a tape
measure before installing.  There is nothing precise about tower sections or
hardware.

John KK9A


To:towertalk at contesting.com
Subject:[TowerTalk] Rohn 45
From:les <lkemble at charter.net>
Date:Wed, 24 Jul 2013 15:48:04 -0400
List-post:<towertalk at contesting.com">mailto:towertalk at contesting.com>

I am pre assembling a rohn45 tower but one section will not line up, it
appears to be about 1/8 of an inch out on one leg. What is the best way to
align the tower section? 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk