[TowerTalk] Rohn 45

[W3YY]

Good idea.

I've also used a couple of pieces of 3/8" to 1/2" threaded rod with a female
threaded coupler.  You can use this to spread tower legs or bring them
closer with the something to grab the tower legs on the end of the threaded
rod.  Simple and amazingly effective.   I hope my brief description paints a
clear picture.  

73, Bob - W3YY


-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
Cqtestk4xs at aol.com
Sent: Thursday, July 25, 2013 1:18 AM
To: TOWERTALK at contesting.com
Subject: Re: [TowerTalk] Rohn 45

You can bang on the various cross bars with a mallet on the  two towers
where they meet up.  Pound up to bring the legs closer, pound  down to
spread them.
 
Bill K4XS/KH7XS
 
 
In a message dated 7/25/2013 12:58:40 A.M. Coordinated Universal Tim,
lkemble at charter.net writes:

I am pre  assembling a rohn45 tower but one section will not line up, it
appears to  be about 1/8 of an inch out on one leg. What is the best way to
align the  tower  section?

_______________________________________________



_______________________________________________
TowerTalk  mailing  list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk