[TowerTalk] Electronic Winch replacement
Fred Serota
fserota at msn.com
Sat Jun 29 11:28:28 EDT 2013
Thank you all for great ideas and now I appreciate N6RK's great ideas and
site.
Fred, K3BHX
-----Original Message-----
From: Bryan Swadener
Sent: Friday, June 28, 2013 10:41 PM
To: towertalk at contesting.com
Cc: fserota at msn.com
Subject: Re: [TowerTalk] Electronic Winch replacement
Hi Fred,
I use Rick N6RK's drill adapter to drive the Fulton winches
on my UST TX-472. I drive it with a Milwaukee
"Super Hawg" drill (400rpm/13.5A). If I don't stop, it takes
only a few seconds to raise/lower it or tilt it up/down.
The thing is a MONSTER. It's a factory-refurbished unit
that I found on eBay. There are always several listed.
A plus is, I can still use the manual winch, if necessary.
Another plus is, I can drill VERY LARGE holes in just about
ANYTHING.
vy 73,
Bryan WA7PRC
> Date: Fri, 28 Jun 2013 14:11:53 -0400
> From: "Fred Serota" <fserota at msn.com>
> To: <towertalk at contesting.com>
> Subject: [TowerTalk] Electronic Winch replacement
>
> Any one with experience replacing their Fulton
> winch with an electronic winch? Any
> recommendations appreciated.
>
> I changed to a worm drive, but it is even harder
> to turn. Too stiff for a drill attachment.
Fred, K3BHX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list