[TowerTalk] FW: need motor shaft pulley US Tower HDX-572

[Matt]

Please confirm the diameter with your old cracked pulley but I believe you
will find that it is 2.5" diameter with a 5/8" shaft bore for use with a
1/2" width belt.   Any bearing or supply house should have a replacement -
suggest you take the old one with you.   If you don't have access to a
bearing supply then you can also use Grainger's.

Good luck,
Matt
KM5VI

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
Kenneth Sobel
Sent: Thursday, April 17, 2014 4:16 PM
To: towertalk at contesting.com
Subject: [TowerTalk] need motor shaft pulley US Tower HDX-572

I have a US Tower HDX-572MDPL since 1998.
Motor was replaced in 2011.
Motor shaft pulley cracked in 2012 and was replaced by tower guy who has
since left the business.
Now the replacement pulley has cracked.

I ordered a new pulley from US tower, but they sent a 3.5 inch pulley for
the cables instead of the smaller pulley for the motor shaft. I did clearly
explain that I needed the motor shaft pulley.

I called US tower last Friday April 11, but the woman who answered said that
she was filling in and someone would get back to me.

I called again on Monday April 14, but got transfered to voicemail. And no
one returned my call.

Does anyone know the specs for the motor shaft pulley so that I can buy one
on the internet?

Ken
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk