[TowerTalk] 40M Homebrew Vertical - mounting ideas solicited

[Hector Garcia,XE2K]

In that case you need to get a long piece of fiberglass rod to separate the radiator  above the metal to  avoid that
 distortion   and mount just below the radial plate,  with this you can solve all and less things to buy or install 
 
J.Hector Garcia  XE2K / AD6D
Mexicali B.C  DM22fp / El Centro
P.O.Box 73 
El Centro CA 92244-0073
http://xe2k.net
Tweeter @XE2K




________________________________
 From: Larry Banks <larryb.w1dyj at verizon.net>
To: Tower Talk <towertalk at contesting.com> 
Sent: Wednesday, January 22, 2014 10:31 AM
Subject: Re: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited
 

Thanks Hector and Matt,

I have already checked out all of the various places:  DX Engineering, MFJ, etc.  They all show aluminum alongside of the driven element in some fashion.  My modeling shows that doing this distorts the RF field so I wish to not have ANY metal alongside of the driven element.  I do plan on using the DX Engineering Resin Support Blocks where appropriate.

I just looked at KX4O's web site and actually didn't see anything that was directly helpful.

Thanks & 73!

Larry -- W1DYJ







--------------------------------------------------------------------------------

----- Original Message ----- 
Check out the pictures of the various DX Engineering tilt over plate products.  That oughta prime the mental pump! 


Take care and good luck on your project!


Matt
KK4CPS
  ----- Original Message ----- 
  From: Hector Garcia,XE2K 
  To: Larry Banks ; Tower Talk 
  Sent: Wednesday, January 22, 2014 12:36 PM
  Subject: Re: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited


  Follow the DXE concept for vertical  raising  if you do not want to buy 
  and yes you can build with metal places, just use the  insulators/clamps from DXE  to hold the radiator
  take a look to the KX4O vertical on the web  and get more ideas
  good luck with the project

  J.Hector Garcia  XE2K / AD6D
  Mexicali B.C DM22fp / El Centro
  P.O.Box 73 
  El Centro CA 92244-0073
  http://xe2k.net
  Tweeter @XE2K





------------------------------------------------------------------------------
  From: Larry Banks <larryb.w1dyj at verizon.net>
  To: Tower Talk <towertalk at contesting.com> 
  Sent: Wednesday, January 22, 2014 9:17 AM
  Subject: [TowerTalk] 40M Homebrew Vertical - mounting ideas solicited


  Hi all,

  I am building a homebrew 40M vertical with raised radials.  (Yes, I have studied the N6LF and K3LC literature.)  

  It will be sitting on a 10 foot metal mast.  I am looking for ideas for mounting the driven element.  I want to be able to tilt the vertical over without effecting the radials.  Obviously, the radials and driven element must not be electrically connected to the mast or each other.  The mounting method should not effect the radiation pattern -- implying that it cannot be fabricated out of metal.  I also want to be able to raise the vertical myself without my XYL needing to help me.  I plan on fabricating this myself, only purchasing raw materials. 

  I am open to any weird ideas!  Pictures are especially helpful.  

  73 -- Larry -- W1DYJ

  _______________________________________________

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk