[TowerTalk] Yaesu G-800sdx rotor pinout

[Pete Smith N4ZR]

My manual shows a 7-pin connector with 6 wires used.  Each pin goes to 
the corresponding number on the controller input.  Pins 4 and 5 are the 
motor.  Pin 3 is ground and one end of the pot.  Pin 2 is the wiper of 
the pot. Pin 1 is the other end of it. Pin 6 goes to pin 6 on the 
controller, but the schematic shows it not connected to anything on the 
rotor end

73, Pete N4ZR
Check out the Reverse Beacon Network at
http://reversebeacon.net,
blog at reversebeacon.blogspot.com.
For spots, please go to your favorite
ARC V6 or VE7CC DX cluster node.

On 5/22/2014 12:12 AM, Tom Horton wrote:
> OOPS!!!< I did it again! Sorry!
>
> Does any one have the pin out for rotor itself?
> Thanks, Tom K5IID
>
>
>
>
>
> There is no joy in Mudville!
> http://www.dfwcontest.com
>
>
> K5IID Tom Horton  Hillsboro, TX
> E sorter for ARRL W5 bureau
> Same call for 57 years!
>
>
> --- On Wed, 5/21/14, Tom Horton <k5iid at sbcglobal.net> wrote:
>
>> From: Tom Horton <k5iid at sbcglobal.net>
>> Subject: Yaesu G-800sdx rotor pinout
>> To: "Tower Talk" <towertalk at contesting.com>, DFWcontest at yahoogroups.com, ctdxcc at kkn.net, lsdxa at yahoogroups.com
>> Cc: "FT-1000mp" <FT-1000MP at yahoogroups.com>
>> Date: Wednesday, May 21, 2014, 11:07 PM
>> There is no joy in Mudville!
>> http://www.dfwcontest.com
>>
>>
>> K5IID Tom Horton  Hillsboro, TX
>> E sorter for ARRL W5 bureau
>> Same call for 57 years!
>>
>>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>