[TowerTalk] RMC-1000 remote - what type of cable to run?

[Mike Fahmie via TowerTalk]

 And even though the RMC-1000 switch is turned off, line noise can still propagate along the line, so for several reasons it is prudent to separate signal and control lines.-Mike-
 
      From: Jim Brown <jim at audiosystemsgroup.com>
 To: towertalk at contesting.com 
 Sent: Thursday, November 6, 2014 3:28 PM
 Subject: Re: [TowerTalk] RMC-1000 remote - what type of cable to run?
   
On Thu,11/6/2014 11:55 AM, Howard W6HDG wrote:
> I then emailed him again and double checked that it could run in the 
> same conduit with coax and rotor cables and he replied,  "Yes, as I 
> said, it would be off while transmissions/radio operation ".

Sorry, that's a wrong answer. If the cables carry 120VAC, they MUST NOT 
be in the same conduit with low voltage wiring. As I recall, the break 
point is something like 48V.

73, Jim K9YC


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk