[TowerTalk] Binding tower

[Bill Aycock]

Mike--
Since this happened just after Rotor work, I would suspect that as the 
cause. Where is the Rotor with respect to the top?
I would take a close look at the Rotor body for any scratches, etc.
Bill--W4BSG

-----Original Message----- 
From: Mike Reublin NF4L
Sent: Sunday, August 16, 2015 5:44 PM
To: towertalk reflector
Subject: Re: [TowerTalk] Binding tower

Anybody know a traveling tower mechanic?
73, Mike NF4L


> On Aug 15, 2015, at 6:13 AM, Mike Reublin NF4L <nf4l at comcast.net> wrote:
>
> I had the HG-70HD down to replace the rotor. When I put it back up, it 
> binds about 3 feet from full extension enough to stall the 24V wheelchair 
> motor that drives a Fulton #3000 winch.
>
> I can't see any hang up thru binocs.  When I collapse it, and tilt it 
> over, how do I find the jam, and how can I repair it? I don't have enough 
> room to extend it fully when it's horizontal.
>
> 73, Mike NF4L
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk 


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus