[TowerTalk] LMR-600: Crimp or Clamp Connectors?
Patrick Greenlee
patrick_g at windstream.net
Thu Jun 4 09:09:44 EDT 2015
I have read information from a credible source that properly done crimp
connections actually cold weld the materials together and are superior
to soldering. While not a direct answer to your question it makes me
lean toward the crimp solution.
Patrick
On 6/4/2015 6:28 AM, Richard Thorne wrote:
> I'm going to replace all of the RG213 coax on my current tower with
> LMR-600. I've been researching connectors.
>
> Looks like there are two varieties, crimp and clamp connectors. After
> watching a few you tube videos of the installation process of both,
> I'm leaning towards the crimp type. It does require a good crimp
> tool, but it looks a little more robust than the clamp variety.
>
> Any opinions out there if one is better than the other?
>
> Thanks
>
> Rich - N5ZC
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
More information about the TowerTalk
mailing list