[TowerTalk] clamp on trhust bearing

[Jorge Diez - CX6VM]

For lateral loads



-----Mensaje original-----
De: TowerTalk [mailto:towertalk-bounces at contesting.com] En nombre de Roger (K8RI) on TT
Enviado el: domingo, 01 de noviembre de 2015 12:29 p.m.
Para: towertalk at contesting.com
Asunto: Re: [TowerTalk] clamp on trhust bearing

Thrust bearing to support lateral loads, or to take load off the rotator for changes?  Split blocks work great for lateral loads.  Oil soaked hard wood, or high density PE.

73

Roger (K8RI)

On 11/1/2015 6:20 AM, Jorge Diez - CX6VM wrote:
> Hello
>
>   
>
> I have a yaesu 065 thrust bearing broken up in the tower, after a 
> rotor replacement.  Inside a mast with two antennas
>
>   
>
> I don t want to remove all antennas and mast to replace the thrust 
> bearing from 200 ft tower, so wondering if there s a CLAMP ON thrust 
> bearing or crapodine I can get to replace it without need to remove 
> all antennas and mast
>
>   
>
> Thanks,
>
> Jorge
>
> CX6VM/CW5W
>
>
>
> ---
> El software de antivirus Avast ha analizado este correo electr nico en busca de virus.
> https://www.avast.com/antivirus
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


-- 

73

Roger (K8RI)


---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


---
El software de antivirus Avast ha analizado este correo electrónico en busca de virus.
https://www.avast.com/antivirus