[TowerTalk] G-2800DXA Resistance readings

[Jim Brown]

On Sun,9/13/2015 3:30 PM, D. Drake wrote:
> Pins 1, 2 and 3 go to the 500 ohm position pot
> with pin 2 being the wiper.  Also pin 3 is
> grounded at the rotor.  So my measured resistance
> from pin 1 to 3 was 506 ohms.  Pin 1 to 2 was 288
> ohms and pin 2 to 3 was 221 ohms with the rotor at
> 45 degrees at the full CCW position pin 1-2 was
> 502 ohms and at the CW stop pin 1-2 was 70 ohms.
>
>   
>
> Pins 4 and 5 go to the motor and with the rotor
> not at a mechanical stop the resistance was 12
> ohms

Hmmmm. That's exactly the opposite of the schematic I remember seeing 
online, as well as opposite of their smaller rotator (GXE1000?). Pins 1 
and 2 are the motor, 3, 4, and 5 is the position pot.

73, Jim K9YC