[TowerTalk] C19XR Feed Point Parallel Wire Connection.
AE1P
ae1p at arrl.net
Fri Nov 11 06:18:06 EST 2016
Roger,
A piece of #14 romex with the ground pulled out would be better, I can't
remember exact length,
but I believe it was around 12-14"... I have a pic on Photobucket
somewhere ,just type in AE1P...
Hope this helps...
73,
Neil
AE1P
On 11/11/2016 6:13 AM, Roger (K8RI) on TT wrote:
> The driver assembly instructions for the C19XR say: " The next part
> installs the parallel driver wires between the 10 mtr driver feed
> points and the 20 mtr feed points" I do not have this part, or even a
> photo.
>
> Outside of ordering this part and waiting-- Would a piece of 450 ohm
> ladder line work for this? Otherwise, what would be better?
>
> 73
>
> Roger (K8RI)
>
>
> ---
> This email has been checked for viruses by Avast antivirus software.
> https://www.avast.com/antivirus
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
73,
Neil,
AE1P
More information about the TowerTalk
mailing list