[TowerTalk] C19XR Feed Point Parallel Wire Connection.
Roger (K8RI) on TT
K8RI-on-TowerTalk at tm.net
Fri Nov 11 09:56:03 EST 2016
On the C19XR it's closer too 20-21 inches
Thanks to all who answered
73
Roger (K8RI)
On 11/11/2016 Friday 6:18 AM, AE1P wrote:
> Roger,
>
>
> A piece of #14 romex with the ground pulled out would be better, I
> can't remember exact length,
>
> but I believe it was around 12-14"... I have a pic on Photobucket
> somewhere ,just type in AE1P...
>
> Hope this helps...
>
> 73,
>
> Neil
>
> AE1P
>
>
> On 11/11/2016 6:13 AM, Roger (K8RI) on TT wrote:
>> The driver assembly instructions for the C19XR say: " The next part
>> installs the parallel driver wires between the 10 mtr driver feed
>> points and the 20 mtr feed points" I do not have this part, or even
>> a photo.
>>
>> Outside of ordering this part and waiting-- Would a piece of 450 ohm
>> ladder line work for this? Otherwise, what would be better?
>>
>> 73
>>
>> Roger (K8RI)
>>
>>
>> ---
>> This email has been checked for viruses by Avast antivirus software.
>> https://www.avast.com/antivirus
>>
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>>
>
--
73
Roger (K8RI)
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
More information about the TowerTalk
mailing list