[TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

[K0DAN]

http://bama.edebris.com/manuals/

-----Original Message----- 
From: Herbert Schoenbohm 
Sent: November 17, 2016 20:50 
To: K0DAN 
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor 

Thanks for info Dan.  Can you send me the link for BAMA as this site is 
not known to mr?


Thanks, Herb

KV4FZ


On 11/17/2016 3:56 PM, K0DAN wrote:
> I am pretty sure the G450 is not interchangeable with the G-800, 
> G1000, and G2800 controllers. However, the G800, G1000, and G2800 can 
> be interchanged. And, with suitable connector changes or use of a 
> pigtail, the SDX and DXA versions can also be swapped.
>
> The schematics are on BAMA, and you can compare where the units are 
> similar/different.
>
> GL es 73
> dan
> k0dan
>
> -----Original Message----- From: Herbert Schoenbohm
> Sent: November 17, 2016 07:36
> To: towertalk at contesting.com
> Subject: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor
>
> I have an orphan Yaesu G-8000DXA controller and would like to know if I
> can replace by G-450A control box with it without any modification?
> The plugs are the same and from the schematic the control circuit is
> similar.  But I would like to know first before I brick the rotor on the
> tower.  Please help.
>
>
>
> Herb Schoenbohm, KV4FZ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk