[TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

[Herbert Schoenbohm]

Thanks Henk that's good information.  i guess i have two G-800DXA 
controllers to sell on eBay.


On 11/21/2016 4:38 AM, Henk PA5KT wrote:
> The G450XL uses an AC24V motor.
>
> G800/1000 models are DC 24 V.
>
> Not interchangeble.
>
> Dont know if the G450A is the same as G450XL. I cannot find a 
> schematic of the G450A.
> If it uses 3 wires to control your motor it is AC.
> 2 wires it is DC.
>
> 73 Henk PA5KT
>
> Op 11/17/2016 om 14:36 schreef Herbert Schoenbohm:
>> I have an orphan Yaesu G-8000DXA controller and would like to know if 
>> I can replace by G-450A control box with it without any 
>> modification?   The plugs are the same and from the schematic the 
>> control circuit is similar. But I would like to know first before I 
>> brick the rotor on the tower.  Please help.
>>
>>
>>
>> Herb Schoenbohm, KV4FZ
>>
>> _______________________________________________
>>
>>
>>
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk