[TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

[Joe K2UF]

I have the schematic for the 450A which is an AC rotor. If you want a copy I
can send the PDF.

73  Joe K2UF 

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Henk
PA5KT
Sent: Monday, November 21, 2016 3:39 AM
To: towertalk at contesting.com
Subject: Re: [TowerTalk] Yaesu G-8000 DXA controller with G-450 rotor

The G450XL uses an AC24V motor.

G800/1000 models are DC 24 V.

Not interchangeble.

Dont know if the G450A is the same as G450XL. I cannot find a schematic of
the G450A.
If it uses 3 wires to control your motor it is AC.
2 wires it is DC.

73 Henk PA5KT

Op 11/17/2016 om 14:36 schreef Herbert Schoenbohm:
> I have an orphan Yaesu G-8000DXA controller and would like to know if 
> I can replace by G-450A control box with it without any
> modification?   The plugs are the same and from the schematic the 
> control circuit is similar.  But I would like to know first before I 
> brick the rotor on the tower.  Please help.
>
>
>
> Herb Schoenbohm, KV4FZ
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2016.0.7924 / Virus Database: 4664/13447 - Release Date: 11/21/16