[TowerTalk] HyGain 155CA dampening rope

[Richard Solomon]

Whenever I used Poly Rope in the
elements, I would use Epoxy. First
at the far end, then tension the rope
with a weigh and epoxy the near end.

Never had a failure.

Also, did the same on verticals. Never
needed Guy Ropes on them.

73, Dick, W1KSZ

On Wed, Jun 21, 2017 at 11:08 AM, john at kk9a.com <john at kk9a.com> wrote:

> Hygain uses very thin wall 7/16 diameter element tips attached to a much
> larger swedged tube. In my experience these elements rattle and break with
> no rope so it is probably a good idea to use it. I do not like trapping in
> water with end caps so perhaps you can fasten the rope using a cable tie.
>
> John KK9A
>
>
> To:     "towertalk at contesting.com" <towertalk at contesting.com>
> Subject:        [TowerTalk] HyGain 155CA dampening rope
> From:   David Aslin G3WGN <david at aslinvc.com>
> Date:   Wed, 21 Jun 2017 14:22:22 +0000
>
>
> Mindful of Steve's 'Prime Directive' which suggests I absolutely should
> use the
> dampening rope in my recently acquired used 155CA, what is the experience
> of
> the TowerTalkian brains trust of the need for  the rope in a 155BA/CA at a
> relatively exposed site?
> 73, David G3WGN  M6O
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>