[TowerTalk] HyGain 155CA dampening rope

David Aslin G3WGN david at aslinvc.com
Wed Jun 21 17:25:50 EDT 2017


Thanks to all for the wisdom, both on and off-reflector.
Clearly the rope should be used with this antenna, as insurance against the PITA of taking it down to fix a broken element, if for no other reason.  And I learned too that the vibrations that lead to element failure can be just as easily caused by a low velocity wind as a high one - so my exposed site is not the real reason to use the rope.
I also got some very helpful practical suggestions on end cap installation and torque balancing the antenna.
I love this reflector! I'm good to go now with best practice for this antenna.  Thanks again guys!
73, David G3WGN  M6O


-----Original Message-----
From: Richard Solomon [mailto:dickw1ksz at gmail.com] 
Sent: 21 June 2017 20:43
To: towertalk <TowerTalk at contesting.com>
Subject: Re: [TowerTalk] HyGain 155CA dampening rope

Whenever I used Poly Rope in the
elements, I would use Epoxy. First
at the far end, then tension the rope
with a weigh and epoxy the near end.

Never had a failure.

Also, did the same on verticals. Never
needed Guy Ropes on them.

73, Dick, W1KSZ

On Wed, Jun 21, 2017 at 11:08 AM, john at kk9a.com <john at kk9a.com> wrote:

> Hygain uses very thin wall 7/16 diameter element tips attached to a 
> much larger swedged tube. In my experience these elements rattle and 
> break with no rope so it is probably a good idea to use it. I do not 
> like trapping in water with end caps so perhaps you can fasten the rope using a cable tie.
>
> John KK9A
>
>
> To:     "towertalk at contesting.com" <towertalk at contesting.com>
> Subject:        [TowerTalk] HyGain 155CA dampening rope
> From:   David Aslin G3WGN <david at aslinvc.com>
> Date:   Wed, 21 Jun 2017 14:22:22 +0000
>
>
> Mindful of Steve's 'Prime Directive' which suggests I absolutely 
> should use the dampening rope in my recently acquired used 155CA, what 
> is the experience of the TowerTalkian brains trust of the need for  
> the rope in a 155BA/CA at a relatively exposed site?
> 73, David G3WGN  M6O
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>



More information about the TowerTalk mailing list