[TowerTalk] Screws for T2X tewrminal board

[John Simmons]

Buy the longer screws and cut them. The hardware store will have a screw 
cutter that looks like a crimper that will do the job well. Buy extra 
screws in case you cut them too short.

73,
-John NI0K

> Dave Thompson <mailto:thompson at mindspring.com>
> Thursday, June 29, 2017 4:23 PM
> I have two manuals one as CDE and the last as Hy-Gain (not MFJ). 7 of 
> the 8 screws are OK but (stainless Phillips head) but one is a non 
> stainless flat head. I went to Ace hardware and the owner knew what 
> type of screw it is (8-32 left twist thread) but he says they are 
> rare. I hate to use a rusty screw but It looks Ok after spraying with 
> Pre-Lub 6. Does anyone know where I can get at least 8 or more flat 
> head stainless screws. The ones Ace stocks are too long and he was not 
> sure he could order them.
>
> These are the screws in the terminal strip part 51465-10) that you 
> attach the rotor cable or quick connect.
>
> Thanks in advance.
>
> 73 Dave K4JRB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk