[TowerTalk] Yaesu Rotator stops to one of the rotation side

[FERNANDO MUGUERZA VIDEGARAY]

Dana:Check if rotors heading dial at controller is offset and is at the end of rotation that could made it to stop one way.
 The adding of a 500 ohm potentiometer as suggested is  a good solution for checking,on my Yaesu controller GS1000SDX,disconnect pins 1,2&3 and connect the outside pins of the pot at 1 & 3,the center at 2 at the back of rotator,turn it and rotor should follow! Another check is place a DC voltmeter at pin 4 & 5 and see if you get + & - 20 volts for 450 degree rotation. Also check the
limit switches and the diodes they have across.(D20 & D21)
 Good luck(buena suerte)
 Fernando,XE2FL


Saludos,
Fernando José Muguerza
Cel. 81.1589.2930
Email. Fernandojmuguerza at gmail.com
Email. xe2fl.kf5mn at gmail.com

Enviado desde mi iPhone