[TowerTalk] Rotator Bolt Patterns

[Raymond Benny]

The Ham M and Ham 1 - 4 series rotators use (4) 1/4 " bolts.

The T2X uses (6) 1/4" bolts. The two additional bolts are in the same
radius as the 4 other bolts, but just centered between two of bolts on
opposite sides.

Ray,
N6VR

On Dec 1, 2018 5:23 PM, <john at kk9a.com> wrote:

I would not let bolt pattern limit your rotator choices. I have not owned a
Hy-Gain rotator in decades. Drilling holes or elongating the existing ones
is very easy. Your rotator shelf may already have elongated holes, I do not
recall doing anything to install a Yaesu G-2800 in my P40A Rohn 55G tower.

John KK9A


Kim Elmore N5OP Wrote:

I'm investigating rotor that will fit the same bolt pattern as a T2X but
that are a bit beefier. Mine works well, but in windy conditions, I
can't turn may antennas  due to wind imbalance. What beefire rotators
will accommodate the same bolt pattern?

Kim N5OP

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk