[TowerTalk] Guy Anchor Question

Wes Stewart wes_n7ws at triconet.org
Tue Sep 18 15:53:10 EDT 2018


Seems to me that if the threads on the rod are fully engaged with the threads on 
the coupler then you have maximum strength.  Additional threads screwed into air 
add nothing.  The visual would be disconcerting of course.

Wes  N7WS


On 9/18/2018 12:02 PM, Ed G wrote:
> I have one set of guys on my 60 ft tower where the two turnbuckles for the mid and top guys are about at their maximum limit. There is maybe an inch of thread left to make adjustments on each of the rods. I really need to let out a bit more and tighten up the other two sets of guys to get the tower perfectly vertical.
>
> How far out can one safely open up the turnbuckle adjustments?
>
> Of course I can re-install a couple new guy grips a bit farther out on the EHS, and that would allow me to close up the turnbuckles, but I’m investigating another option.  Anyone see any problem with turning out the screw-in guy anchor on the affected set of guys perhaps one turn?  It’s a five foot anchor and it is in pretty far already (about 6 inches extending from the ground).  Just unscrewing the guy anchor one turn will probably give me the slack I need in the one set of guys without having to open up the turnbuckle to where I have almost no threads left in the adjusting rods.
>
> --Ed—
>
>



More information about the TowerTalk mailing list