[TowerTalk] XHHW wire

[Patrick Greenlee]

I have 375 amp service (or was it 350?) anyway the wires from the pole 
xformer to the house are buried and are aluminum. They feed side by side 
200 amp panels, each with a main breaker. I have never touched their 
connection to the main breakers.  This setup has been in place for over 
15 years.  I can kill the main breakers one at a time and use an allen 
wrench with a "cheater" for increased torque to make sure the clamping 
force is good and plenty but I suspect I'll find the connection to be tight.

Sub panels off these 2 each 200 amp panels feed healthy arc welders, 
table saws, kilowatt linear, etc and other man toys with no problems.  
No dimming or blinking lights.  I'll trport back if the 15 + year 
connections have loosened any.

(Why 2 ea 200 amp panels instead of a single 400?   A good 400 cost then 
$1200-$1500 so 2 ea good 200's was a comparative bargain, saving several 
hundred dollars.)

Patrick        NJ5G

On 2/24/2020 7:46 AM, Rob Atkinson wrote:
> I have a few problems with this wire.  My experience with aluminum is
> that it is not worth the trouble integrating it into the rest of the
> antenna system when it comes to bonding it to other metals.  I
> appreciate the light weight and lower cost but aluminum has another
> undesirable property:  It cold flows so clamps on it eventually come
> loose and then you have resistance and heat.  This is why aluminum
> house wire which was tried in the 1960s came to a quick end--too many
> cold flows, heat and fires.   I hope it isn't coming back for that
> purpose.
>
> I have my 200 amp service drop to my home using aluminum.  I don't
> like it but I can't make the power company use copper.  Every few
> years I check the lugs on the main breaker to make sure they are still
> tight.   This is one area where an IR camera would come in handy.   It
> WILL cold flow eventually and you'll know it when your lights flicker
> or dim briefly when a big load like A/C comes on.
>
> I was dismayed to see that QST ran an article by some sort of RF
> expert on how to construct open wire feedline using aluminum AWG 8 or
> maybe it was 6, stranded wire.  Ridiculous overkill for ham power, and
> he spliced line sections together using what appeared to be steel
> clamps.  Those clamps will lose their grip in a few years and he'll
> have problems, besides the use of steel for RF.   None of this came up
> in the article.    Then there was the line Z due to the spacing and
> diameter of AWG 8 cable but that's outside the focus here.
>
> 73
> Rob
> K5UJ
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk