[TowerTalk] Flat Wrenches
Ron Gorski
ron-n9au at sbcglobal.net
Tue Jul 21 19:12:21 EDT 2020
Check McMaster-Carr online catalog
N9AU
-----Original Message-----
From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Don
Sent: Tuesday, July 21, 2020 10:27 PM
To: Towertalk <towertalk at contesting.com>
Subject: [TowerTalk] Flat Wrenches
And metric.
Don W7WLL
On 7/21/2020 2:03 PM, K9MA wrote:
Speaking of which, it's hard to find wrenches thin enough to lock two
6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that works,
but sooner or later I'm going to lose one of those up on the tower. All the
small wrench sets ("Ignition Wrenches") available seem to be too thick.
Short of grinding them down, does anyone know where to get thin ones in SAE
sizes?
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
This email has been checked for viruses by AVG.
https://www.avg.com
More information about the TowerTalk
mailing list