[TowerTalk] Flat Wrenches

[Don]

Ah McMaster, should have thought of that. Need a 14MM flat to get at the 
inner nut of the bearings in the XYL's glider chair. A  happy wife makes 
it easier to be an active ham!!!!!

Don W7WLL

On 7/21/2020 4:12 PM, Ron Gorski wrote:
> Check McMaster-Carr online catalog
> N9AU
>
> -----Original Message-----
> From: TowerTalk <towertalk-bounces at contesting.com> On Behalf Of Don
> Sent: Tuesday, July 21, 2020 10:27 PM
> To: Towertalk <towertalk at contesting.com>
> Subject: [TowerTalk] Flat Wrenches
>
> And metric.
>
> Don W7WLL
>
>
> On 7/21/2020 2:03 PM, K9MA wrote:
>
> Speaking of which, it's hard to find wrenches thin enough to lock two
> 6-32 or 8-32 nuts together. I have one old, cheap, Craftsman set that works,
> but sooner or later I'm going to lose one of those up on the tower. All the
> small wrench sets ("Ignition Wrenches") available seem to be too thick.
> Short of grinding them down, does anyone know where to get thin ones in SAE
> sizes?
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
>