[TowerTalk] Swinging gate antenna mount

[Richard Thorne]

One option is to use a green heron rt21 controller and setup soft limits.  That way the rotor will stop before the antenna or side mount hits the tower.

Rich - N5ZC

Sent from my iPhone

> On Jun 5, 2020, at 4:39 PM, Robert Harmon <k6uj at pacbell.net> wrote:
> 
> Dumb question.   When using the swinging gate, how do you make sure when the rotator swings it around it won't hit the tower ?
> 
> 
> Bob
> K6UJ
> 
> 
> 
>> On Jun 5, 2020, at 1:52 PM, Grant Saviers <grants2 at pacbell.net> wrote:
>> 
>> I have a Rohn 65 design in CAD, never built it, went with rings instead.  Should have done the arms.  All 1/4" HRS steel plate, standard angles and channel, plus 2" NPT pipe, although other tube/pipe choices are easy.  Different leg diameters depend on the u-bolt size (minor hole location change needed). Designed for hot dip galvanizing.  I designed for two antennas for up to 20' of pipe between top bearing and rotator. Or one antenna on a short pivot "mast". Uses a standard mount rotator at the bottom (my plan was Orion 2800) and a UHMW bearing at the top.  Make the plates on a laser or waterjet cutter.  Weld it up and HDG.
>> 
>> Reply off list and I well send 3D pdf's to review. Enough interest and some weld shop might make them.  Everything should UPS except the pipe, buy it locally.  Adding tabs and slots to the top and bottom supports for self fixturing of the welding would be nice.
>> 
>> Grant KZ1W
>> 
>>> On 6/5/2020 11:46, Jon Zaimes via TowerTalk wrote:
>>> Try here: http://www.w9iix.com/ii00012.htm
>>> Jon P. Zaimes, AA1K
>>> Tower climber for hire
>>> Website: aa1k.us
>>> Cell: 302-632-2353
>>> Email: jz73 at verizon.net
>>> Hug your favorite tower every day, and always stay connected to it
>>>> On Friday, June 5, 2020 mike stokes <mike9v at gmail.com> wrote:
>>> I am looking for one as well.  Please reply to the list.
>>> 73
>>> Mike
>>> KK9V
>>> On Fri, Jun 5, 2020 at 2:20 PM Ignacy Misztal <no9e at arrl.net> wrote:
>>>> Does anybody make swinging gate mounts? I need one for 45G.
>>>> Ignacy, NO9E
>>>> _______________________________________________
>>>> 
>>>> 
>>>> 
>>>> _______________________________________________
>>>> TowerTalk mailing list
>>>> TowerTalk at contesting.com
>>>> http://lists.contesting.com/mailman/listinfo/towertalk
>>>> 
>> _______________________________________________
>> 
>> 
>> 
>> _______________________________________________
>> TowerTalk mailing list
>> TowerTalk at contesting.com
>> http://lists.contesting.com/mailman/listinfo/towertalk
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk