[TowerTalk] Anti-Climb US Tower TX-455

[Mike & Becca Krzystyniak]

Would a Hardie board work here.  

-----Original Message-----
From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of
n0tt1 at juno.com
Sent: Thursday, October 29, 2020 8:49 PM
To: dana.roode at gmail.com; Towertalk at contesting.com
Subject: Re: [TowerTalk] Anti-Climb US Tower TX-455

The "secret" to using wood outdoors is to soak it down good
with Thompson's Water Seal (following label directions) before
painting.  Last's a VERY long time!  

Tempered hardboard is good for making the panels.  Metal panels
can be homebrewed using galvanized sheet metal.  Heating contractors
have the heavier guages.

Usual disclaimer...just a satisfied customer of Thompson's, etc.

73,
Charlie, N0TT

On Thu, 29 Oct 2020 17:37:44 -0700 Dana Roode K6NR <dana.roode at gmail.com>
writes:
> My TX-455 is in a fenced property but I'm gone a lot so years ago I 
> built
> anti-climb panels for it out of wood.  I found someone's design that 
> worked
> well.  However, wood warps after a decade or so, even if you paint 
> it.
> 
> Does anyone make anti-climb panels for a TX-455, out of metal?  I 
> also have
> a Rohn-25 with wooden anti-climb, I think I've seen anti-climb from 
> Rohn.
> 
>   dana
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
> 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk at contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk