[TowerTalk] Long span lanyard for wire antenna

Haring family dcharing at gmail.com
Wed Apr 21 15:07:54 EDT 2021


You'll always have sag... less sag, with more tension...

Here is a calculator, with both ends at the same elevation. Using 1/2"
Phillystran for a 350' span, you have something like 23' of sag with a 100#
tension in the cable. You want very little sag? Better be prepared to have
significant lateral stress, and make sure your anchors and guying system is
designed for it. I didn't look any further for a calculator which would
allow uneven end heights...

https://www.spaceagecontrol.com/calccabl.htm?F=100&a=350&q=0.15&g=32.18503937&Submit+Button=Calculate

regards,

Dave N3AC

On Wed, Apr 21, 2021 at 12:48 PM <john at kk9a.com> wrote:

> I am not a mechanical engineer but I am guessing that if he uses
> Phillystran and allows for perhaps 10' of sag there is not a lot of
> tension on the cable.  Rope may be worse if it gets wet and heavier.
>
> John KK9A
>
>
> >
> > On 4/21/2021 9:04 AM, Steve K8LX wrote:
> >> Rather than be tempted to use high enough tension where turnbuckles
> >> are needed, let it sag a little, give up a few feet of height -
> >> your tower guy systems will appreciate it.
> >>
> >> -Steve K8LX
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>


More information about the TowerTalk mailing list