[TowerTalk] HDBX48 tiltover base info
Kim Elmore
cw_de_n5op at sbcglobal.net
Wed Jun 30 18:51:15 EDT 2021
I measured mine with a ruler (not a caliper or micrometer) and they look
to be right at 3/8".
Kim N5OP
On 6/30/2021 1:14 PM, John Simmons wrote:
> I obtained a used HDBX48 with the tiltover base consisting of tubing
> and u-shaped pieces to attach to 1" threaded rod. However I'm missing
> the u-shaped pieces. The Rohn drawing I have doesn't specify the
> thickness of the u-shaped pieces. Does anyone have a drawing or actual
> base to find the thickness of the material the u-shaped piece is made
> from? Looking at the drawing I'm thinking the piece is the same
> thickness as the square plate at the bottom of the threaded rod, which
> is 3/8". If so I can weld up what I need from flat stock.
>
> 73,
> -de John NI0K
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
--
Kim Elmore, Ph
Kim Elmore, Ph.D. (Adj. Assoc. Prof., OU School of Meteorology, CCM, PP
SEL/MEL/Glider, UAS, N5OP, 2nd Class Radiotelegraph, GROL)
/“I occasionally play works by contemporary composers and for two
reasons. First to discourage the composer from writing any more and
secondly to remind myself how much I appreciate Beethoven." – Jascha
Heifetz/
More information about the TowerTalk
mailing list