[TowerTalk] TIC plastic gears
Zivney, Terry
00tlzivney at bsu.edu
Thu Jan 5 19:15:04 EST 2023
Does anyone know of a source for the small plastic gear that fits on the
multi-turn pot inside the Tic-Gen ring rotor motor box? The one that lost some teeth
had 55 teeth, was 7/8 inch OD and had a metal insert to fit the 1/4 inch
shaft of the pot. I have a replacement from the pot removed from a
slave motor which didn't need the position indicator, but I would like
to have a replacement for just in case. These motors were late 1990's
vintage, with the sheet metal box, and the 1022 size ring.
I don't want to have to go to the external pot assembly TIC-Gen uses now.
Terry N4TZ
More information about the TowerTalk
mailing list