[TowerTalk] U-Bolt Sources

[Larry Schulman]

Go on the DX Engineering internet site and they sell stainless U-bolts and
saddle clamps from .5 inch to 4 inch that may be what you are looking for.

Larry-K9IQ

On Mon, Jun 5, 2023 at 8:55 AM Mike <mryan001 at tampabay.rr.com> wrote:

> Be VERY careful with eBay sources unless you want METRIC sizes. If you run
> across ANY that you like ANYWHERE better ask them if they are METRIC
> threads
> or SAE.  That is unless you don't care. -Mike, K4CVL
> -----Original Message-----
> From: TowerTalk [mailto:towertalk-bounces at contesting.com] On Behalf Of Jim
> W7RY
> Sent: Friday, June 02, 2023 4:56 PM
> To: towertalk at contesting.com
> Subject: Re: [TowerTalk] U-Bolt Sources
>
> DX Engineering.
>
> Jim W7RY
>
>
>
> On 6/2/2023 11:03 AM, Pete Smith N4ZR wrote:
> > I need some good quality stainless U-bolts for 2" OD tubing,  >
> preferably
> the type with the bolt plate that itself fits the tubing
>  > OD, rather the simple flat plates sold by local hardware stores. I >
> have looked on line, without success so far. Any ideas? >
> --
> Thanks and 73, Jim W7RY
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk at contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>