[TRLog] QSX problems

[Kenneth E. Harker]

     At N5CQ M/S this past weekend, we had a distinct problem with QSX
info on 40M packet spots.  We were using 6.48 with a Yaesu FT-1000MP.  When 
going to a packet spot on 40SSB with QSX info in the band map, VFO A
would tune to the RX frequency fine, but VFO B would end up 150 kHz 
below where it should have been.  (i.e., a spot '7039.9 JA8RWU QSX 7215'
would tune VFO A to 7039.9 and VFO B to 7065.0.)  At least I think it was 
150 kHz - I'll admit that I was too busy to diagnose it fully.  We ended up
just tuning by hand on 40M.

-- 
----------------------------------------------------------------------------
Kenneth E. Harker      "Vox Clamantis in Deserto"      kharker@cs.utexas.edu
University of Texas at Austin                  Amateur Radio Callsign: KM5FA
Department of the Computer Sciences         President, UT Amateur Radio Club
Taylor Hall TAY 2.124               Maintainer of the Linux Laptop Home Page
Austin, TX 78712-1188 USA            http://www.cs.utexas.edu/users/kharker/
----------------------------------------------------------------------------

--
FAQ on WWW:               http://www.contesting.com/trlogfaq.html
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:	  http://web.jzap.com/n6tr/trwish.html