[TRLog] SIIG Serial PCI

[NR1DX]

Ward
Been there done that too  ....but that is not the problem we are trying to
solve here.
What address did the Siig ports come up for on COM3 and 4?
What IRQ are they using?
Have you been able to get TR to recognize a PCI card at a non standard address
(i.e other than 3E8,2E8,2F8,3F8).?
And most importantly can you get TR to recognize a PCI card at COM5 and COM6?If
so using what IRQ?
A Comp -USA 2 ser/1 parallel? Are you sure this is a PCI card and not an ISA
card? I was recently  (last week ) in Comp USA and the only 2S/1P cards they
had were ISA (by Siig by the way, these are jumpered ISA cards and do work at
least for COM 3 and 4)

Dave
NR1DX


At 05:08 PM 11/1/00 -0800, Ward Silver wrote:
>
>I just went through a PCI-related problem in getting TR to run under
>Win98.  I have a CompUSA PCI 2-ser/1-par card that dropped in and
>installed fairly straightforwardly, but TR couldn't see it, even though
>the Windows System/Device Manager showed COM1/2 on the m'board and COM3/4
>on the PCI board.
>
>The solution turned out to be installing the correct DOS drivers and
>running TR from the command mode (hit F8 during boot up and select
>"command mode" from the menu).  Once I went that route, everything has
>been hunky dory.
>
>73, Ward N0AX
>
>
>--
>FAQ on WWW:              
<http://www.contesting.com/FAQ/trlog>http://www.contesting.com/FAQ/trlog
>Submissions:              trlog@contesting.com
>Administrative requests:  trlog-REQUEST@contesting.com
>Problems:                 owner-trlog@contesting.com
>Feature Wishlist:  
<http://web.jzap.com/n6tr/trwish.html>http://web.jzap.com/n6tr/trwish.html
>  

--
FAQ on WWW:               http://www.contesting.com/FAQ/trlog
Submissions:              trlog@contesting.com
Administrative requests:  trlog-REQUEST@contesting.com
Problems:                 owner-trlog@contesting.com
Feature Wishlist:	  http://web.jzap.com/n6tr/trwish.html