[Trlog] Re: Trlog Digest, Vol 7, Issue 1

[Ron D. Rossi]

There are three versions of OmniVI firmware. Each acts a bit differently from 
a radio communications point of view. That is why some work with the Icom 
error preventing measures put on with V6.72 and some don't. The Ten Tec 
section of the code needs some further special attention. I tried to bypass 
the Icom fixes for Omnis, but did not get it right.
-- 
73 es God Bless de KK1L...ron (kk1l at arrl.net) <><
Ron Rossi ASIC PE Test -- IBM Microelectronics
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l


>>>Doug Smith W9WI said:
> On Tue, 2003-07-01 at 11:30, trlog-request at contesting.com wrote:
> > I loaded Version 6.73 and ran Field day this past weekend.  I had a TS-2000
     
> > connected to COM1 and the TenTec OMNI VI to Com2.  I had a major problem wi
    th 
> > the computer and the TenTec communicating.  Most of the time, they were not
     
> > communicating.  About 20% of the time, the program functioned normally.  Th
    e rest 
> > of the time, it was not good.  
> 
> We used an Omni VI and 6.73 at K4FUN, with 99.9% success.  (on rare
> occasions the wrong band or mode would display briefly.  We have 12
> "SSB" QSOs in the log - out of just shy of 1,500 - though in fact the
> rig never left CW mode)  
> 
> We selected IC761 as the rig and were operating at 2400 baud.  K1KY
> (whose Omni it was) did *something* in the rig's setup menus but he did
> it pretty quickly & I'm not sure what he did.  
> -- 
> Doug Smith W9WI
> Pleasant View (Nashville), TN  EM66
> http://www.w9wi.com
> 
> _______________________________________________
> Trlog mailing list
> Trlog at contesting.com
> http://lists.contesting.com/mailman/listinfo/trlog