[Trlog] TRLog v6.72 and Icom 735

[Ron D. Rossi]

Is transceive turned off? That is the first thing to check!

If it is already off, then you can try setting the rig type to some other ICOM 
(IC737??) and the receiver address to 4. There was change to the code which 
forced a strict check for data length to/from the radio. The IC735 is listed 
as having a shorter frequency data string. MAYBE yours does not?

-- 
73 es God Bless de KK1L...ron rossi(kk1l at arrl.net) <><
Support Programmer for TRLog http://www.qth.com/tr
QTH: Jericho, Vermont
My page: http://www.qsl.net/kk1l

>Hi
>
>Just upgraded to v6.72 from v6.56 for the NEQP(I know, that's too long but
>it wasn't by choice) and could not get the rig interface to work with my
>Icom 735 (I know, rig is a dinosaur but works well for Field Day and a
>backup). The interface worked fine for my Icom 735 when using v6.56 and
>earlier versions for past Field Days and other contests, but after the
>upgrade to 6.72 the program will only (sometimes) receive the initial freq
>and mode from the Icom, then it locks up and won't change as I tune, also
>can't send cw to the parallel port. I am using the same input config file I
>used with v6.56, Receiver Address 4 etc. I have not changed any other
>parameters either. I tried it with the old v6.56 afterwards on the same
>computer and it works fine, but of course I couldn't work NEQP with that
>because it wasn't supported. Any suggestions?
>
>73 es tnx
>Bill, W1LEE
>_______________________________________________
>Trlog mailing list
>Trlog at contesting.com
>http://lists.contesting.com/mailman/listinfo/trlog