[Trlog] PCMCIA Serial Cards

[Mark Beckwith]

TRlog guys - I'm still having PCMCIA woes - please read: 


>Did you try the System Soft Card and Socket Services recommended by Quatech?
>73, Yngvi TF3YH


Thanks Yngvi, I was not aware Quatech recommends System Soft software.  I have two different sets of card and Socket Services software (CardWare and CardSoft) and neither one is getting the job done yet.  I have found where all the addresses are in the computer and the card, and I am now trying to get them all to agree on using the same addresses - I hope that does it!  So far I haven't been able to manipulate them.  Still working on it.  The fact that the computer recognizes the PCMCIA card I think means the card and socket services software is working right, except that I can't seem to get the addresses adjusted in the PC.  Also, TRlog has a command line instruction that shows the port addresses, but I can't get TRlog to use a different port address than what it shows.  I wonder if that part of TRlog is not working, because I think it gives you a "change" option but when I use it nothing changes or the computer freezes, I forget which.

Thanks - Mark, N5OT