[UK-CONTEST] Kenpro rotator

[Cooper, Stewart]

I recommend really thick sticky grease and a steady hand (over a cardboard
box).

I once read that there are two types of radio amateurs: those who have
picked up the bearings from a rotator off the shack floor, and those who
have never dismantled a rotator.

Stewart
AFF

-----Original Message-----
From: Steve Bunting [mailto:stephen.bunting at kcl.ac.uk]
Sent: 26 January 2004 21:58
To: uk-contest at contesting.com
Subject: [UK-CONTEST] Kenpro rotator


Hi folks,

Not really a contesting question, but this is the kit I take out /p, so
it is related!

I have just replaced the pot in my Kenpro KR-600 rotator head. I am now
trying to put he b*****y thing back together. Two questions:

1) I can't get the all the balls that came out to go back in! Any
tips? (Yaesu must spares located in the head, hi!)

2) How do you get all the balls to stay put as you put the casings
together? Grease? There wasn't that much in there to start with....

If you have worked on one of these I'd appreciate some advice.
73
Steve
M0BPQ 

_______________________________________________
UK-Contest mailing list
UK-Contest at contesting.com
http://lists.contesting.com/mailman/listinfo/uk-contest

Scanned by IFB http://www.ifb.net for spam/UCE and virus content.
IFB Spam-Score: (0)
----------------------------------------------------------------
Offshore Design Ltd
www.odl.co.uk
This email is for the sole use of the intended recipient(s) and may contain
confidential and privileged information. You should not disclose its
contents to any other person. Any unauthorised review, use, disclosure or
distribution is prohibited. If you are not the intended recipient, please
notify the sender immediately.