[WriteLog] Packet Terminal Setup

[Darack, Zev]

I've used writelog with a couple of different TNC's and never had to do
anything special.  

Open up the packet window and select the com port that the TNC is on then
basically type the command....for me it was "connect W2JT".  If the TNC is
not in command mode you might need to use another program to put the TNC in
command mode and then start writelog.

73,
Zev N2WKS

 -----Original Message-----
From: 	Kevin Brown - KC0CZI [mailto:kc0czi@midmoskywarn.net] 
Sent:	Tuesday, December 03, 2002 11:49 PM
To:	writelog@contesting.com
Subject:	[WriteLog] Packet Terminal Setup

I had a friend call me about setting up a TNC connected to a com port
for his packet cluster operations for the ARRL 160 test.

I personally don't have a local packet cluster nearby (have to use
DxTelnet) so I'm clueless.  I've scanned through the K9JY site and
couldn't get enough detail to make it work. 

Could someone point me to a place where I could find some detail on
setting up a packet comm port - including any modification(s) to the
writelog.ini and setup->ports section?

He's new to Writelog and is using a KPC9612 for access to the
packetcluster on VHF.

I'll basically copy/paste your response to Dennis.

_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog



CONFIDENTIALITY NOTICE:  This communication and any attachments are
confidential, and are only for the use of the intended recipient.  If
you have received this transmission in error, any disclosure, copying,
distribution or the taking of any action in reliance upon this
communication is strictly prohibited.  If you have received this
communication in error, please contact the sender immediately and
delete the original message.  Thank you.