[WriteLog] TS-2000 & Laptop
WA9ALS - John
wa9als@starband.net
Thu, 4 Jul 2002 07:54:35 -0500
I believe that Rocketport's literature says it's 7- and 8-bit only - at
least their PCI card is that way - thus no FSK. At least Rocketport has
this information available. Most of the USB serial vendors don't have that
info available on their website, and you should try asking them about 5-bit
on the telephone! hee hee
----- Original Message -----
From: "Jim McDonald" <n7us@arrl.net>
To: "Don Hill AA5AU" <aa5au@bellsouth.net>; "WriteLog Reflector"
<Writelog@contesting.com>
Sent: Wednesday, July 03, 2002 9:25 PM
Subject: Re: [WriteLog] TS-2000 & Laptop
>
> I use Rocketport USB hub with 4 serial ports. I use it for Yaesu rotor
> control and controlling my Mark-V with WL and DXbase, connecting to my 87A
> for its AlphaRemote software, and previously syncing a Palm (now using USB
> with a Palm M515). I haven't tried it for FSK, as I use the only serial
> port on my (now old) Dell with the RigBlaster Plus (the lazy guy's
approach)
> and MMTTY.
>
> The only problem that I've had has never been experienced by anyone else
> I've talked to, which is the PC sometimes hangs when booting into Win98
SE.
>
> I got it at buy.com:
> http://www.buy.com/retail/product.asp?sku=10238214&hdwt=30805&loc=101
where
> it's now $126.95, but I see it's on back order.
>
> I tried an Ultegra before and had RFI. I've used Belkins OK, but again
> didn't try FSK.
>
> BTW, I have the 4-port USB hub from Costco, and it has been fine. No
> special drivers required. They now sell a pair of small ones with power
> supplies for about $13 I think.
>
> Jim N7US
>
>
>
> ----- Original Message -----
> From: "Don Hill AA5AU" <aa5au@bellsouth.net>
> To: "WriteLog Reflector" <Writelog@contesting.com>
> Sent: Wednesday, July 03, 2002 12:40 PM
> Subject: Re: [WriteLog] TS-2000 & Laptop
>
>
> Jack et al,
>
> With only one serial port on the laptop, you will be forced to use
> the USB port one way or the other in order to run FSK.
>
> I've been studying this USB thing all day today. From what I can
> gather, you will need to get a USB-to-Serial adapter. And that may or
> may not be easier said than done.
>
> It has been documented that not all USB-to-Serial adapters will run
> FSK. Some will and some won't. However, it has also been documented
> that most USB-to-Serial adapters can be used for radio control, but
> not all of them.
>
> So the problem is knowing which USB-to-Serial adapters to buy. It
> may be more beneficial to use the USB-to-Serial adapters for radio
> control and use the serial port on the laptop for FSK (I am assuming
> you will be running FSK and not AFSK for RTTY).
>
> Since you mentioned PSK31, perhaps you are thinking of using
> only AFSK. In this case, you don't need a USB-to-Serial adapter at all
> since AFSK is strictly using the soundcard to generate the RTTY & PSK31
> audio
> tones and you would use radio control via your COM to key PTT.
>
> However, I cannot imagine anyone with a radio that has FSK not using
> it for RTTY.
>
> Your laptop must have a sound card in order to use WinRTTY, which is
> the WriteLog RTTY "program" and is installed when WriteLog is installed.
> WinRTTY uses the "WriteLog RTTY Receiver" to decode signals received
> from a sound card and has it's own on screen tuning indicator (which I
might
> add is the best on screen tuning indicator I've ever used).
>
> If your laptop does not have a sound card, then you could still get on
> RTTY using an external TNC such as a PK232 or HAL DXP-38. But again,
> you would need an extra serial port and would need a USB-to-Serial adapter
> if you want to run an external TNC and still have radio control. It is
> recommended
> not giving up rig control even if you have to buy a USB-to-Serial adapter
in
> order to have it. Radio control will give you PTT.
>
> Since you mentioned that you were running Win2000, I am guessing your
> laptop has a sound card. In this case, by all means, get RTTY up and
> running
> using the WriteLog RTTY Receiver. Once you get comfortable with that, you
> might consider using the MMTTY Plug-in for WriteLog which is available
> from the WriteLog website. Support for the MMTTY Plug-in for WriteLog
> can be found at www.geocities.com/writelog which is a support site that
> I maintain and not to be confused with the official WriteLog website at
> www.writelog.com.
>
> Getting back to your questions about cables. Yes, you will need cables
one
> way or the other. For information on what cables may be needed for either
> AFSK or FSK, PTT, etc. refer to "Getting Started on RTTY" at
> www.aa5au.com/rtty. The discussion is geared toward MMTTY, but the
> hardware connections are the same.
>
> If you are in a hurry to get up and running you could always buy one of
the
> 3 RIGblaster models which put isolations transformers and opto-isolators
> for the various required interface cables and circuits all in a neatly
made
> package
> but for a pretty price. Only the RIGblaster Plus will run FSK.
>
> Now getting back to the main reason I replied (other than trying to help
> Jack),
> I was wondering if those out there using USB-to-Serial adapters could
> comment
> on the specific brand, make and model of the one(s) they are using and if
> they
> know if they run FSK, radio control on a certain radio, and/or PTT.
>
> I would like to start a list of different USB-to-Serial adapters and what
> they will
> or will not do and put them on the "Getting Started on RTTY" web pages.
>
> Thanks and sorry for the long reply, but hey, he asked for answers! hi
> 73, Don AA5AU
>
>
> ----- Original Message -----
> From: "Cantrell, Jack (Jack)** CTR **" <cantrell@lucent.com>
> To: <writelog@contesting.com>
> Sent: Wednesday, July 03, 2002 11:08 AM
> Subject: [WriteLog] TS-2000 & Laptop
>
>
> > I am new to Writelog and am having a little trouble hooking things up.
I
> have a TS-2000 and a laptop computer with only one 9-pin
> port. These two are connected via their 9-pin ports so that Writelog can
> read the operating frequency and mode. I would like to
> hook up RTTY and PSK31. Do I need any software other than what comes on
the
> Writelog CD? Is this a direct computer to rig hardware
> connection? Where can I get the appropriate cable[s]? At this point I
have
> only USB and LPT ports available. Adapter cables may
> be needed. The laptop runs Windows 2000. Thanks for any tips, Jack -
> ab0ox@arrl.net
> >
> >
> >
> > --- StripMime Report -- processed MIME parts ---
> > multipart/alternative
> > text/plain (text body -- kept)
> > text/html
> > ---
> > _______________________________________________
> > WriteLog mailing list
> > WriteLog@contesting.com
> > http://lists.contesting.com/mailman/listinfo/writelog
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>
>