[WriteLog] Another CW keying issue

Gil Baron gbaron@charter.net
Sat, 12 Oct 2002 09:11:50 -0500


Try to test the interface by using a battery on the line that would be DTR.
If you can key it that way then you interface is ok. If not, you may have a
shorted transistor or other problem.

Next get a digital meter (or a good analog meter) and put it on the DTR line
to see if it is switching when you key. If it is not you have a setup
problem in WriteLog.




One thing I can assure you is that it is NOT the fault of WriteLog (properly
configured) and it is NOT the fault of WIN2K as I used it on WIN2K..

You cannot use the LPT port to key on WIN2K or WINXP without a driver which
WriteLog has not deemed a necessity so you would have to use a third party
driver but that is not your problem if you are using a com port.





> -----Original Message-----
> From: writelog-admin@contesting.com
> [mailto:writelog-admin@contesting.com]On Behalf Of Joe Stepansky
> Sent: Saturday, October 12, 2002 6:45 AM
> To: writelog@contesting.com
> Subject: [WriteLog] Another CW keying issue
>
>
> As relatively straightforward as WL has been to set up, I've been having
> little luck with some of the hardware interfaces.  This is a different CW
> issue, one that's causing me to test my sanity.  The archives show a
> similar question asked a few months ago, but no reply.  I'm using Win2K,
> which may itself be the problem, dunno.
>
> Here's the problem.  I built a very simple interface to go from
> 9-pin COM1
> to the CW key jack on the back of my IC-765 (the poster several
> months ago
> also had an Icom rig).  I basically took the interface for a 25
> pin serial
> interface found in the CT manual and modified it for 9-pin (DTR on in 4
> instead of 20, and GND on pin 5 instead of 7).  This worked fine before,
> but now when I plug the key jack in the 765 transmits continuously.  I've
> had that happen with the old interface, turned out a couple of the wires
> were shorting.  But that's not happening here, since I took a
> multimeter to
> it and everything appears to be fine.
>
> This is the circuit description, anybody see anything wrong?
>
> 1.  Using a 9-pin connector, I took a line from pin 4 (DTR), through a 1K
> resistor into the base of a 2N2222 transistor.
> 2.  Took a line from pin 5 (GND) to the 2N2222 emitter and on to
> the ground
> of the key jack.
> 3.  A line from the 2N2222 collector to the positive terminal of
> the CW key
> jack.
>
> Again, this has worked for me in the past with a 25 pin port;  I'm
> wondering if there's something basic I'm missing, or something going on
> with Win2K and the Icom.
>
>
> 73, Joe KQ3F
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>