[WriteLog] ICOM IC-751A, UX14 and WriteLog

[K6RB]

Pawel,

The solution to the problem is to go to the port settings window and change
"automatic" to "9600" baud. I have the same module in my IC-751A and had the
same problem. Make sure that the "polling" box is selected "on," too. Once I
changed the baud rate from automatic to 9600, it started working properly.
Good luck.

Also, another possible problem is that the board's configuration switch has
the "tranceive" function (switch #3) selected "off." Make sure it is in the
"on" position. That is different than it says in the documentation.

Rob K6RB


----- Original Message -----
From: "Pawel SP7PS" <pawel at sp7ps.pl>
To: <writelog at contesting.com>
Sent: Wednesday, June 04, 2003 1:27 PM
Subject: [WriteLog] ICOM IC-751A, UX14 and WriteLog


> Hello WLoggers,
> One of my friends has just bought UX14 module for his IC-751A manufactured
> by Piexx.
> I spent all evening trying to configure the rig and software and have not
> succeed.
>
> It seems, that WL tries to connect radio, because if I turn off the radio
> there is message "No rig!" in entry window. When I turn on the radio there
> is no frequency information in the window. Instead of I can see "kHzCW" or
> "kHzCW". But not eaxt frequency.
>
> I also checked this combo IC-751A/UX14 with DX4WIN and also problems - no
> reading frequency nor mode.
>
> Have you any experience or advices?
>
> 73's
> Pawel, SP7PS (SN7N in contests)
> http://sp7ps.pl
>
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
>