[WriteLog] Still working to get LPT1 to work.

[Simon Brown (HB9DRV)]

Error 487 is 'invalid address' - you may have the option of defining the 
actual address for your printer port. Although there are recognised defaults 
these are not cast in stone.

Simon Brown
---
www.sysgem.com www.hb9drv.ch www.laax.ch

----- Original Message ----- 
From: "Stan Staten" <stan.staten at verizon.net>


> Saw recent WL list post on Direct I/O and sure enough it is updated
> since I last tried it.  However, I still am not able to get the LPT1
> port "un-greyed" out.  Also getting the following error when I run IRQ
> Monitor: "Error 487 occurred when trying to open Direct I/O".  Error
> reports have gone unresponded to by whoever sees them.  Any suggestions
> as to where to turn would be sincerely appreciated.
>
> 73 Stan, N3HS