[WriteLog] "Zero's" in contact serial Number's

[Bruce Meier]

Well - I tried a few different things.

This is exactly what I did.

> Close WriteLog if you have it open
> Open Writelog.ini
> Insert this line exactly as typed - I put mine after the Configuration
section   [Cut-Numbers]
    NOTE - the dash is needed (for me)
> Then input the series of numbers you want
    NOTE:  I used 9=N and 0=T
> Close and save WriteLog.ini
> Open Writelog - and check WriteLog.ini to see if the info you put in is
EXACTLY the same as when you put it in.
    NOTE:  For some reason (no clue why) the dash was not there the first
couple times
> Then - before you do anything - SAVE CONFIGURATION

This worked for me.   It did not work until I checked for the DASH and did a
SAVE CONFIGURATION before testing to see if it worked.

Good luck,
Bruce - N1LN



----- Original Message ----- 
From: "Shelby Summerville" <k4ww at arrl.net>
To: <writelog at contesting.com>
Sent: Tuesday, May 24, 2005 20:36
Subject: Re: [WriteLog] "Zero's" in contact serial Number's


> I appreciate all the offers of assistance, but regardless of what I try,
I'm
> unable to get "cut numbers" to work, for me? I'm pleased that it works for
> most, but not all.
> Please don't concern yourselves, too much, as I certainly don't intend to.
> If the other station can listen to "zero's", instead of "T's", I certainly
> can.
> Bottom line...it doesn't work, has never worked, and it's not a problem,
at
> least for me.
>
> C'Ya, Shelby - K4WW
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>